Merci de respecter le format des signatures > 
Voir les contributions
1
Modifications / [ Tuto ] Démontage et Montage pommeau de vitesse gti
« le: 17 octobre 2012 à 11:18:45 »
Je ne sais pas mais j'ai trouvé un vendeur ebay qui vend des soufflets de remplacement dans les 11 € pour l'avoir contacté il dit qu'il arrive a l'aide d'un tournevis a séparer le pommeau du soufflet.
J'avoue que ca m'interesse car la piece vw complete coute 80€.
Si quelqu'un a des infos la dessus ?
http://cgi.ebay.fr/VOLKSWAGEN-GOLF-5-SOUFFLET-LEVIER-CUIR-03-2009-/280618807078?pt=FR_JG_Auto_Tuning&hash=item41562f2f26#ht_1015wt_1397
Voici l'explication que la personne m'a fournie en anglais, j'avoue ne pas tout comprendre :
"I removed the gear knob by prizing the metal clamp away from the plastic with a screwdriver being careful not to
chew the plastic too much, untill it was just loose enough to allow the plastic to expand over the retaining bump with a fairly hard vertical pull of the gear knob.
The plastic collar holding the gaiter on is a tight push fit onto the bottom of the knob with an alignment slot to prevent twisting. This can be prized down with a screwdriver being careful
not to damage the visible bit of the knob. Might need a spot of rubbery glue to stop seam popping out at bottom.
I'm sure others would find this information useful."
J'avoue que ca m'interesse car la piece vw complete coute 80€.
Si quelqu'un a des infos la dessus ?
http://cgi.ebay.fr/VOLKSWAGEN-GOLF-5-SOUFFLET-LEVIER-CUIR-03-2009-/280618807078?pt=FR_JG_Auto_Tuning&hash=item41562f2f26#ht_1015wt_1397
Voici l'explication que la personne m'a fournie en anglais, j'avoue ne pas tout comprendre :
"I removed the gear knob by prizing the metal clamp away from the plastic with a screwdriver being careful not to
chew the plastic too much, untill it was just loose enough to allow the plastic to expand over the retaining bump with a fairly hard vertical pull of the gear knob.
The plastic collar holding the gaiter on is a tight push fit onto the bottom of the knob with an alignment slot to prevent twisting. This can be prized down with a screwdriver being careful
not to damage the visible bit of the knob. Might need a spot of rubbery glue to stop seam popping out at bottom.
I'm sure others would find this information useful."